Filter
Top Products
106 Chapter 3 Install the Business Communications Manager & Expansion Unit Platform Base Chassis
P0993133 03
Figure 58 Fasten the expansion unit to the equipment rack
Install the Expansion Unit on a Flat Surface
You can install the Business Communications Manager expansion unit on any flat surface that can
support the weight of the unit, and which is within 5 m (16 ft.) of the Business Communications
Manager platform base chassis.
1 Attach the supplied rubber feet to the corners of the bottom of the expansion unit.
2 Position the expansion unit on the table or shelf.
3 Ensure that you leave enough space around the unit for ventilation and access to the cables and
media bay modules.
Connect the Expansion Unit to the Business Communications
Manager
After the expansion unit has been installed in the desired location, use the supplied DS256 cable to
connect it to the Business Communications Manager platform base chassis.
1 Plug one end of the cable into the DS256 connector on the Business Communications
Manager expansion unit. Refer to Figure 59.
Note: Do not place anything on top of the expansion unit chassis.