Chapter 12 Install Companion or DECT Systems 253
Installation and Maintenance Guide
Use this procedure to mount the RPI unit.
1 Partially install two #10 50 mm (2 in.) screws using the dimensions shown in Figure 162.
Figure 162 RPI mounting holes
2 Open the cover with a screwdriver. Push the screwdriver in, and then down, to release the latch
on the right side. Remove the cover by lifting it up. Refer to Figure 163.
Figure 163 Open the RPI cover
3 Hang the RPI on the two screws. Tighten the screws.
325 mm
(13 in.)
25 mm
(1 in.)
50 mm
(2 in.)
300 mm
(12 in.)
Keyholes