Filter
Top Products
Chapter 10 Replace Data Cards and Processing Hardware 221
Installation and Maintenance Guide
Install the WAN card
Use this procedure to install a replacement WAN card. If you are installing a new WAN card for
the first time, refer to “Initialize a new WAN card” on page 222.
1 Disconnect the Business Communications Manager from the AC power outlet.
2 Partially remove the base function tray from the platform base chassis. If required, remove the
base function tray completely from the platform base chassis (see “Remove the base function
tray” on page 150).
3 Remove the base function tray bezel (if applicable).
4 Insert the WAN card in the same PCI slot from which you removed the original card. Refer to
Figure 147.
5 Push firmly on the WAN card until it sits completely in the top PCI riser card connector.
6 Position the PCI cover plate on the front of the base function tray such that the base function
tray and cover plate screw holes align.
7 Position the PCI cover plate locking screw in the PCI cover plate. Tighten the PCI cover plate
locking screw until the plate is firmly set in place (see Figure 147).
Figure 147 Install the WAN card
Warning: Protect the hardware components against damage from electro-static
discharge. Always wear a ground wrist strap before you handle components. Always place
the components in static-free container.
PCI cover plate
WAN card
1
2
1. Install the
WAN card
2. Install the PCI
cover plate