Filter
Top Products
Chapter 4 Install, remove or replace the Media Bay Modules 113
Installation and Maintenance Guide
Figure 62 Overview of removing a media bay module
Remove a media bay module from the Business Communications
Manager platform base chassis
Use this procedure to remove a media bay module from the Business Communications Manager
platform base chassis. Remove the media bay modules after the system is powered down.
1 Power down the Business Communications Manager system (see Shut down the system on
page 110).
2 Remove any cabling from the media bay module faceplate.
3 Grasp the right edge of the MBM ejector lever with your thumb, index and middle fingers.
Pull outward to partially eject the media bay module bay. Pull further on the lever to eject the
media bay module from the bay. Refer to Figure 63 or Figure 64.
4 Grasp the top and bottom edges of the media bay module. Remove the media bay module from
the Business Communications Manager platform base chassis MBM bay (see Figure 63,
Figure 64). Place the media bay module in a clean, safe and static free area.
Shutdown
BCM &
expansion
unit
Disconnect power from
both units
Remove module
Remove module
cables