Filter
Top Products
Chapter 5 Business Communications Manager System Startup 141
Installation and Maintenance Guide
Figure 77 Ethernet crossover cable
Configure your computer
You must configure your computer before you use it to connect to the Business Communications
Manager system.
1 Click Start, Settings, Control Panel.
2 Double click the Network icon.
3 Select your TCP/IP adapter, and then click the Properties button.
4 Click the IP Address tab.
5 Click the Specify an IP address option.
6 In the IP Address field, enter
10.10.10.2.
7 In the Subnet Mask field, enter
255.255.255.0.
8 Click OK.
9 Click OK.
10 Click Yes to restart the PC.
Connect the Ethernet crossover cable
After you configure the computer, connect the computer to the Business Communications
Manager base function tray in the following manner:
1 Shut down the computer.
2 Attach one end of the Ethernet crossover cable to the LAN card on the Business
Communications Manager.
3 Connect the other end of the cable to the network interface card on your computer.
4 Start the computer.
5 Log on to the Unified Manager using the default IP address.
Note: Your interface can differ, depending on what version of system software you are
using. The task in this section is to specify IP and subnet addresses for the computer.
3TD+
6TD-
1RD+
2RD-
3TD+
6TD-
1RD+
2RD-