Garmin G1000 PDAs & Smartphones User Manual


  Open as PDF
of 632
 
190-00498-07 Rev. A
Garmin G1000 Pilot’s Guide for Cessna Nav III
61
FLIGHT INSTRUMENTS
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
When a bearing pointer is displayed, the associated information window is also displayed. The Bearing
Information Windows (Figure 2-18) are displayed at the lower sides of the HSI and give the following
information:
•Bearingsource(NAV,GPS,ADF)
•Pointericon(BRG1=singleline,BRG2=double
line)
•Frequency(NAV,ADF)
•Station/waypointidentier(NAV,GPS)
•GPS-derived great circle distance to bearing
source
WhentheNAVradioistunedtoanILSfrequencythebearingsourceandthebearingpointerisremoved
fromtheHSI.WhenNAV1orNAV2istheselectedbearingsource,thefrequencyisreplacedbythestation
identierwhenthestationiswithinrange.IfGPSisthebearingsource,theactivewaypointidentieris
displayedinsteadofafrequency.
ThebearingpointerisremovedfromtheHSIandNODATAisdisplayedintheinformationwindowif
theNAVradioisnotreceivingaVORstationorifGPSisthebearingsourceandanactivewaypointisnot
selected.
Selecting bearing display and changing sources:
1) Press the PFD Softkey.
2) Press a BRG Softkey to display the desired bearing pointer and information window with a NAV source.
3) Press the BRG Softkey again to change the bearing source to GPS.
4) To remove the bearing pointer and information window, press the BRG Softkey again.
DME INFORMATION WINDOW
The DMEInformationWindowisdisplayedabovetheBRG1InformationWindowonthe360˚HSIandin
aboxaboveandalongsidetheArcHSI.ItshowstheDMElabel,tuningmode(NAV1,NAV2,orHOLD),
frequency,anddistance.Whenasignalisinvalid,thedistanceisreplacedby–.––NMRefertotheAudio
PanelandCNSSectionforinformationontuningtheDME.
NOTE: DME installation is optional.
Displaying the DME Information Window:
1) Press the PFD Softkey.
2) Press the DME Softkey to display the DME Information Window.
3) To remove the DME Information Window, press the DME Softkey again.
 previous next