Filter
Top Products
190-00498-07 Rev. A
Garmin G1000 Pilot’s Guide for Cessna Nav III
36
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
•Fuelandfuelow(gallons,gallons/hour)
Indicates fuel quantities are measured in gallons and fuel flow is measured in gallons per hour.
•Weight(pounds,kilograms)
The weight setting is not applicable to the Nav III.
•Position(HDDD°MM.MM’,HDDD°MM’SS.S”,MGRS)
Affects all position displays.
Change a Display Units setting:
1) While on the System Setup Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the desired eld in the Display Units Box.
3) Turn the small FMS Knob to select from a list of measurement units and press the ENT Key when the desired
unit is highlighted. Press the CLR Key to cancel the action without changing the units.
BaRO tRansitiOn aleRt
See the Flight Instruments section for a discussion on setting the Baro Transition Alert.
aiRsPace aleRts
The Airspace Alerts Box allows the pilot to turn the controlled/special-use airspace message alerts on
or off. This does not affect the alerts listed on the Nearest Airspaces Page or the airspace boundaries
depicted on the MFD Navigation Map Page. It simply turns on/off the warning provided when the aircraft
is approaching or near an airspace.
Alerts for the following airspaces can be turned on/off in the Airspace Alerts Box:
•ClassB/TMA
•ClassC/TCA
•ClassD
•Restricted
•MOA(Military)
•Otherairspaces
An altitude buffer is also provided which “expands” the vertical range above or below an airspace. For
example, if the buffer is set at 500 feet, and the aircraft is more than 500 feet above/below an airspace, an
alert message is not generated, but if the aircraft is less than 500 feet above/below an airspace and projected
to enter it, the pilot is notified with an alert message. The default setting for the altitude buffer is 200
feet.
Change the altitude buffer distance setting:
1) While on the System Setup Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the altitude buffer eld in the Airspace Alerts Box.
3) Turn the FMS Knobs to enter an altitude buffer value and press the ENT Key.