Filter
Top Products
190-00498-07 Rev. A
Garmin G1000 Pilot’s Guide for Cessna Nav III
9
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
Figure 1-4 Data Insertion Pointer
Data is Inserted Above
the Cursor, Indicated
by the Data Insertion
Pointer
15
PROC Key
– Selects approaches, departures and arrivals from the flight plan. If a flight plan is used, available
procedures for the departure and/or arrival airport are automatically suggested. If a flight plan is not used, the
desired airport and the desired procedure may be selected. This key selects IFR departure procedures (DPs),
arrival procedures (STARs) and approaches (IAPs) from the database and loads them into the active flight plan.
16
ENT Key
– Accepts a menu selection or data entry. This key is used to approve an operation or complete data
entry. It is also used to confirm selections and information entries.
17
Dual
ALT Knob
– Sets the selected altitude in the box located above the Altimeter. The
large
knob selects the
thousands (500m for metric), while the small
knob selects the hundreds (50m for metric). Altitude Select is
used by the Automatic Flight Control System in certain modes, in addition to the standard G1000 Altitude
Alerter function.
The following are only available with the GFC 700 AFCS.
18
AP Key
– Engages/disengages the autopilot and flight director. Pressing the
AP
Key activates the flight director
and engages the autopilot in the default pitch axis and roll axis modes. Pressing the
AP
Key again disengages
the autopilot and deactivates the flight director.
19
HDG Key
– Selects/deselects Heading Select Mode.
20
NAV Key
– Selects/deselects Navigation Mode.
21
APR Key
– Selects/deselects Approach Mode.
22
VS Key
– Selects/deselects Vertical Speed Mode.
23
FLC Key
– Selects/deselects Flight Level Change Mode.
24
FD Key
– Activates/deactivates the flight director only. Pressing the
FD
Key turns on the flight director in the
default pitch axis and roll axis modes. Pressing the
FD
Key again deactivates the flight director and removes
the command bars, unless the autopilot is engaged. If the autopilot is engaged, the
FD
Key is disabled.
25
ALT Key
– Selects/deselects Altitude Hold Mode.
26
VNV Key
– Selects/deselects Vertical Navigation Mode.
27
BC Key
– Selects/deselects Back Course Mode.
28 29
NOSE UP/NOSE DN Keys
– Controls the active pitch reference for the Pitch Hold, Vertical Speed, and
Flight Level Change modes.