Filter
Top Products
190-00498-07 Rev. A
Garmin G1000 Pilot’s Guide for Cessna Nav III
241
FLIGHT MANAGEMENT
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
TRIP STATISTICS
The trip statistics are calculated based on the selected starting and ending waypoints and the trip planning
inputs.
In flight plan mode (FPL) with a stored flight plan selected (NN), and the entire flight plan (CUM) selected,
the waypoints are the starting and ending waypoints of the selected flight plan.
In flight plan mode (FPL) with a stored flight plan selected (NN), and a specific leg (NN) selected, the
waypoints are the endpoints of the selected leg.
In flight plan mode (FPL) with the active flight plan selected (00), and the remaining flight plan (REM)
selected,the‘from’waypointisthepresentpositionoftheaircraftandthe‘to’waypointistheendpointofthe
active flight plan.
In flight plan mode (FPL) with the active flight plan selected (00), and a specific leg (NN) selected, the
‘from’waypointisthecurrentaircraftpositionandthe‘to’waypointistheendpointoftheselectedleg.
In waypoint (WPTS) mode these are manually selected waypoints (if there is an active flight plan, these
default to the endpoints of the active leg).
Some of the calculated trip statistics are dashed when the selected leg of the active flight plan has already
been flown.
•DesiredTrack(DTK)-DTKisshownasnnn°andisthedesiredtrackbetweentheselectedwaypoints.
It is dashed unless only a single leg is selected.
•Distance(DIS)-Thedistanceisshownintenthsofunitsupto99.9,andinwholeunitsupto9999.
•Estimatedtimeenroute(ETE)-ETEisshownashours:minutesuntillessthananhour,thenitisshown
as minutes:seconds.
•Estimated time of arrival (ETA) - ETA is shown as hours:minutes and is the local time at the
destination.
- If in waypoint mode then the ETA is the ETE added to the departure time.
- If a flight plan other than the active flight plan is selected it shows the ETA by adding to the departure
time all of the ETEs of the legs up to the selected leg. If the entire flight plan is selected, then the ETA
is calculated as if the last leg of the flight plan was selected.
- If the active flight plan is selected the ETA reflects the current position of the aircraft and the current
leg being flown. The ETA is calculated by adding to the current time the ETEs of the current leg up to
and including the selected leg. If the entire flight plan is selected, then the ETA is calculated as if the
last leg of the flight plan was selected.
•Enroutesafealtitude(ESA)-TheESAisshownasnnnnnFT
•Destinationsunrise and sunset times (SUNRISE, SUNSET) - These times are shown as hours:minutes
and are the local time at the destination.