Garmin G1000 PDAs & Smartphones User Manual


  Open as PDF
of 632
 
190-00498-07 Rev. A
Garmin G1000 Pilot’s Guide for Cessna Nav III
124
AUDIO PANEL AND CNS
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
VFR CODE
The VFR codecanbeenteredeithermanuallyorbypressingthe
XPDR
Softkey, then the
VFR
Softkey.
When the
VFR
Softkeyispressed,thepre-programmedVFRcodeisautomaticallydisplayedinthecodeeld
oftheTransponderDataBox.Pressingthe
VFR
Softkey again restores the previous identification code.
Thepre-programmedVFRCodeissetatthefactoryto1200.IfaVFRcodechangeisrequired,contacta
Garmin-authorized service center for configuration.
Figure 4-38 VFR Code
VFR Code
IDENT FUNCTION
NOTE: In Standby Mode, the IDENT Softkey is inoperative.
Pressing the
IDENT
Softkey sends a distinct identity indication to Air Traffic Control (ATC). The indication
distinguishes the identing transponder from all the others on the air traffic controller’s screen. The
IDENT
Softkey appears on all levels of transponder softkeys. When the
IDENT
Softkey is pressed, a green
IDNT
indicationisdisplayedinthemodeeldoftheTransponderDataBoxforadurationof18seconds.
After the
IDENT
Softkey is pressed while in Mode or Code Selection, the system reverts to the top-level
softkeys.
Press the
IDENT Softkey
to Initiate the
ID Function
IDNT
Indication
Figure 4-39 IDENT Softkey and Indication
 previous next