Garmin G1000 PDAs & Smartphones User Manual


  Open as PDF
of 632
 
190-00498-07 Rev. A
Garmin G1000 Pilot’s Guide for Cessna Nav III
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
407
HAZARD AVOIDANCE
3) Turn the Range knob to set the range to 2/6 nm to allow for full test pattern to be displayed during test.
4) Press the TEST Softkey.
Or:
1) Press the MENU Key and turn the small
FMS
knob
to select ‘Test Mode’.
2) Press the ENT Key.
Figure 6-163 System Test in Progress with Test Pattern
TA at 9 o’clock,
Distance 2.0
nm, 200’ Below,
Climbing
Non-Threat
Traffic at
11 o’clock,
Distance 3.6
nm, 1000’
Above, Level
Proximity
Traffic at
1 o’clock,
Distance
3.6 nm,
1000’ Below,
Descending
Operating
Mode
Test Mode Annunciation
OPERATION
NOTE: The GTS 800 automatically transitions from STANDBY to OPERATE mode eight seconds after takeoff.
The unit also automatically transitions from OPERATE to STANDBY mode 24 seconds after landing.
Afterpower-up,theGTS800isinStandbyMode.TheGTS800mustbeinOperatingModefortrafctobe
displayedandforTAstobeissued.
SelectingtheOPERATESoftkeyallowsthetrafcunittoswitchfromStandbyModetoOperatingModeas
necessary.SelectingtheSTANDBY SoftkeyforcestheunitintoStandbyMode.
Switching from operating mode to standby mode:
On the Traffic Page, select the
STANDBY
Softkey
Or:
1) Press the MENU Key and turn the small
FMS
knob
to select ‘Standby Mode’.
2) Press the ENT Key.
 previous next