Garmin G1000 PDAs & Smartphones User Manual


 
190-00498-07 Rev. A
Garmin G1000 Pilot’s Guide for Cessna Nav III
37
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
To turn an airspace alert on or off:
1) While on the System Setup Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the desired eld in the Airspace Alerts Box.
3) Turn the small FMS Knob clockwise to turn the airspace alert ON or counterclockwise to turn the alert OFF.
aRRival aleRts
The Arrival Alert Box on the System Setup Page allows the Alerts Window arrival alerts to be turned
ON/OFF, and the alert trigger distance (up to 99.9 units) set for alerts in the Alerts Window and the
PFD Navigation Status Box. An arrival alert can be set to notify the pilot with a message upon reaching
a user-specified distance from the final destination (the direct-to waypoint or the last waypoint in a flight
plan). When Arrival Alerts is set to ON, and the set distance is reached, an “Arrival at waypoint” message
is displayed in the PFD Navigation Status Box, and a “WPT ARRIVAL - Arriving at waypoint - [xxxx]” is
displayed in the Alerts Window. When Arrival Alerts is set to OFF, only the PFD Navigation Status Box
message “Arriving at waypoint” is displayed, and it is displayed when the time to the final destination is
approximately ten seconds.
Enabling/disabling the Alerts Window arrival alert:
1) Use the FMS Knob to select the AUX - System Setup Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to select the ON/OFF eld in the Arrival Alert Box.
4) Turn the small FMS Knob clockwise to turn the airspace alert ON or counterclockwise to turn the alert OFF.
Changing the arrival alert trigger distance:
1) Use the FMS Knob to select the AUX - System Setup Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight the distance eld in the Arrival Alert Box.
4) Use the FMS Knob to enter a trigger distance and press the ENT Key.
aUDiO aleRts
The Audio Alert Box on the System Setup Page allows the audio alert voice to be set to male or female.
To change the audio alert voice:
1) While on the System Setup Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the voice in the Audio Alert Box.
3) Turn the small FMS Knob to display and highlight the desired voice and press the ENT Key.
Flight DiRectOR
Not pilot selectable.