Garmin G1000 PDAs & Smartphones User Manual


  Open as PDF
of 632
 
190-00498-07 Rev. A
Garmin G1000 Pilot’s Guide for Cessna Nav III
38
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
Page navigatiOn
The large FMS Knob displays the Page Group Tabs and navigates through the tabs. The small FMS Knob
navigates through the pages listed within a specific group. The number of clicks it takes to display the
Page Group Tabs and change to the next tab can be controlled from the Page Navigation box on the AUX
- System Setup Page.
OFF – Displays the Page Group Tabs with one click of either FMS Knob.
ON – Displays the Page Group Tabs and navigates to the next tab with one click of either FMS Knob.
The pilot can select, from the AUX - System Setup Page, the amount of time the Page Group Tabs are
displayed (in the lower right corner of the MFD). The timeout can range from two to ten seconds.
Selecting page navigation settings:
1) Use the FMS Knob to select the AUX - System Setup Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight the ‘Change On 1st Click’ eld in the Page Navigation Box.
4) Turn the small FMS Knob to select ‘OFF’ or ‘ON’.
5) Turn the large FMS Knob to highlight the ‘Timeout Seconds’ eld in the Page navigation Box.
6) Turn the small FMS Knob to select the desired number of seconds
7) Press the FMS Knob momentarily to remove the flashing cursor.
mFD Data BaR FielDs
The MFD Data Bar Fields Box on the System Setup Page displays the current configuration of the MFD
Navigation Status Box. By default, the Navigation Status Bar is set to display ground speed (GS), distance
to next waypoint (DIS), estimated time enroute (ETE), and enroute safe altitude (ESA).
Change the information shown in an MFD Navigation Status Bar field:
1) While on the System Setup Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the desired eld number in the MFD Data Bar Fields Box.
3) Turn the small FMS Knob to display and scroll through the data options list and press the ENT Key when the
desired data selection is highlighted.
The following data may be selected for display in each of the four fields of the Navigation Status Box.
•Bearing(BRG)
•CrosstrackError(XTK)
•Distance(DIS)
•DesiredTrack(DTK)
•Endurance(END)
•EnRouteSafeAltitude(ESA)
•EstimatedTimeofArrival(ETA)
•EstimatedTimeEnRoute(ETE)
•FuelOverDestination(FOD)
•FuelOnBoard(FOB)
•GroundSpeed(GS)
•MinimumSafeAltitude(MSA)
•TrueAirSpeed(TAS)
•TrackAngleError(TKE)
•Track(TRK)
•VerticalSpeedRequired(VSR)
 previous next