Garmin G1000 PDAs & Smartphones User Manual


  Open as PDF
of 632
 
190-00498-07 Rev. A
Garmin G1000 Pilot’s Guide for Cessna Nav III
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
397
HAZARD AVOIDANCE
TRAFFIC MAP PAGE
TheTrafcMapPageistheprincipalmappageforviewingTIStrafcdatainrelationtotheaircraft’scurrent
positionandaltitude,withoutclutterfromthebasemap.Aircraftorientationonthismapisalwaysheadingup
unlessthereisnovalidheading.MaprangeisadjustablewiththeRANGE Knobfrom2to12nm,asindicated
by the map range rings.
ThetrafcmodeisannunciatedintheupperleftcorneroftheTrafcMapPage.Whentheaircraftisonthe
ground,TISautomaticallyentersStandbyMode.Oncetheaircraftisairborne,TISswitchesfromStandbyto
OperatingModeandthesystembeginstodisplaytrafcinformation.RefertotheSystemStatusdiscussionfor
more information.
Displaying traffic on the Traffic Map Page:
1) Turn the large
FMS
Knob to select the Map Page Group.
2) Turn the small
FMS
Knob
to select the Traffic Map Page.
3) Confirm TIS is in Operating Mode:
Press the
OPERATE
Softkey to begin displaying traffic.
Or:
a) Press the
MENU
Key.
b) Select ‘Operate Mode’ (shown if TIS is in Standby Mode) and press the ENT Key.
“Non-Bearing” Traffic
(System Unable to
Determine Bearing)
Distance is 4.0 nm,
500’ Above,
Descending
Non-Threat
Traffic,
Altitude Not
Reported
Off-Scale Traffic
Advisory
400’ Below, Level
Traffic Status Banner
Annunciations
Traffic Mode Annunciation
“TIS Not Available”
Voice Alert Status
Select
to Mute
“TIS Not
Available”
Voice Alert
Figure 6-157 Traffic Map Page
Traffic Advisory, 500’
Below, Climbing
Non-Threat
Traffic, 2500’
Above,
Descending
Range
Marking
Rings
 previous next