Filter
Top Products
190-00498-07 Rev. A
Garmin G1000 Pilot’s Guide for Cessna Nav III
19
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
WIND
Displays softkeys to select wind data parameters
OPTN 1
Wind direction arrows with headwind and crosswind components
OPTN 2
Wind direction arrow and speed
OPTN 3
Wind direction arrow with direction and speed
OFF
Information not displayed
DME
Displays the DME Information Window
BRG1
Cycles the Bearing 1 Information Window through NAV1, GPS/ waypoint
identifier and GPS-derived distance information, and ADF/frequency
HSI FRMT
Provides access to the HSI formatting softkeys
360 HSI
Displays the HSI in a 360 degree view
ARC HSI
Displays the HSI as an arc
BRG2
Cycles the Bearing 2 Information Window through NAV2 or GPS waypoint
identifier and GPS-derived distance information, and ADF/frequency.
ALT UNIT
Displays softkeys for setting the altimeter and BARO settings to metric
units
METERS
When enabled, displays altimeter in meters
IN
Press to display the BARO setting as inches of mercury
HPA
Press to display the BARO setting as hectopacals
STD BARO
Sets barometric pressure to 29.92 in Hg (1013 hPa if METRIC Softkey is selected)
OBS
Selects OBS mode on the CDI when navigating by GPS (only available with
active leg)
CDI
Cycles through GPS, VOR1, and VOR2 navigation modes on the CDI
DME
Displays the DME Tuning Window, allowing selection of the DME
XPDR
Displays transponder mode selection softkeys
STBY
Selects standby mode (transponder does not reply to any interrogations)
ON
Selects Mode A (transponder replies to interrogations)
ALT
Selects Mode C – altitude reporting mode (transponder replies to identification
and altitude interrogations)
GND
Allows manual selection of ground mode in certain conditions
VFR
Automatically enters the VFR code (1200 in the U.S.A. only)
CODE
Displays transponder code selection softkeys 0-7
0 — 7
Use numbers to enter code
IDENT
Activates the Special Position Identification (SPI) pulse for 18 seconds,
identifying the transponder return on the ATC screen
BKSP
Removes numbers entered, one at a time
IDENT
Activates the Special Position Identification (SPI) pulse for 18 seconds,
identifying the transponder return on the ATC screen
TMR/REF
Displays Timer/References Window
NRST
Displays Nearest Airports Window
ALERTS
Displays Alerts Window