Filter
Top Products
Garmin G1000 Pilot’s Guide for Cessna Nav III
190-00498-07 Rev. A258
FLIGHT MANAGEMENT
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
h) Press the ENT Key twice to activate the direct-to. Note, in Figure 5-123, the magenta arrow indicating the
direct-to OPSHN after the offset waypoint for OPSHN. The preceding offset waypoint indicates the offset
distance and altitude that were previously entered. The remaining waypoints in the loaded arrival procedure
have no database specified altitudes, therefore, dashes are displayed. Keep the CDI centered and maintain a
track along the magenta line to OPSHN.
Note the Direct-to waypoint is within the loaded arrival procedure, therefore, phase of flight scaling for the CDI
changes to Terminal Mode and is annunciated by displaying ‘TERM’ on the HSI.
NOTE: If the loaded arrival procedure has waypoints with altitude constraints retrieved from the database
to be used as is, the altitude must be manually accepted by placing the cursor over the desired altitude,
then pressing the ENT Key. The altitude is now displayed as light blue meaning it is used by the system to
determine vertical speed and deviation guidance.
Figure 5-123 Direct-to Active
12) The aircraft is proceeding to OPSHN. The expected approach is the RNAV LPV approach to runway 35R, so it is
selected.
a) Press the
PROC
Key to display the Procedures Window.