Filter
Top Products
81
CHAPTER 4 I/O PORTS
●
Operation in stop mode
• The output transistors are forcibly turned "OFF" regardless of the PRD0 register value and the pins go to
the high-impedance state if the pin state specification bit in the standby control register (STBC: SPL) is
"1" when the device goes to stop mode. Moreover, to avoid leakage (from floating input pin), input must
be driven by either "1" or "0" when SPL = "1".
Table 4.3-4 "Port 1 pin state" lists the port 1 pin states.
Table 4.3-4 Port 1 pin state
Pin name
Normal operation
sleep mode
stop mode (SPL = "0")
Stop mode (SPL = "1") Reset
P10/SEG28 to P17/SEG35
General-purpose I/O ports/segment
driver output
Hi-Z Hi-Z
SPL: Pin state specification bit in the standby control register (STBC)
Hi-Z: High impedance