Filter
Top Products
REMOTEADMIN & MAINTPROCEDURES
SECTION 200-096-600
FEBRUARY1991
TABLERM-AU
PROGRAM53
LCRSCHEDULEASSIGNMENT
STEP
ACTION
DISPLAY/PRINTOUT
1
Enter Program Mode
>MODE PROG
At the >MODE prompt, enter i 1 B 1
q
. P
2 Enter Program Number 53
P 53
Press
q
. P53
3
Define Route Plan Number
P53 1
Refer to the System Record Sheet and enter the route
plan number (1 - 8).
Example: Route Plan 1, enter 1.
4 Define Schedule Number
P53 1 1
Refer to the System Record Sheet and enter the required
schedule number (1 - 3).
Example: Schedule 1, enter 0 .
5
Enter Code Number 0
P53 1 1 0 0000 0800
The system will display the previously selected time for
P53
the route plan number (step 3) and the schedule number (step 4).
Refer to the System Record Sheet and change the time if required.
Example: Change to 0800. Enter 1 1 1 1 .
Press
q
and repeat steps 3, 4, and 5 for all
lanskchedules.
NOTE: Enter time using 24hour format: [3 m b m .
6 Priority Class Assignment
P53 1 1 1 NNNN 12
Enter the route plan number as defined in step 3.
P53
Enter the schedule number as defined in step 4.
Refer to the System Record Sheet and enter the required
station group number (1 - 4).
Example: Group 1, enter 0 .
The system will display the previously entered route definition
numbers (reference
Program 54).
Refer to the System Record Sheet and enter required
route definition numbers 1 - 4) and press
q
Example: Enter1 and 1 - .
b
Continue to repeat steps 3, 4, and 6 until all plans/schedules
are entered.
7 To Exit Program/Store Data
P53 # #
A) Data was stored when pressing
q
in step 6.
P
B) Continue returning to step 3 until all data is entered
for this program.
C) To exit this program.
Press 1 1
q
.
-44-