Filter
Top Products
SPEED DIAL MEMO
(continued)
LCD NAME/NUMBER DISPLAY
(continued)
4) Press the m button.
l
USER NAME? will appear on the upper line of the LCD.
l
Current information for station NNN will appear on the
lower line of the LCD.
5) Enter the new information viathe dialpad (referto Record LCD
Message method).
l
Up to 16 characters can be recorded.
6) Press the m button.
l
The new information is stored and appears on the top line
of station NNN’s LCD.
l
Station 200’s LCD returns to the normal idle display.
NOTES:
1. To erase the NAME/NUMBER information of another
station from station 200, repeat steps 1 w 6 above and
enter blanks in step 5. Blanks are entered by pressing 0
in the alpha mode.
2. Station NNN may set and clear the NAME/NUMBER
feature anytime:
l
Set:mi]a.
l
Clear: m 11 [I “ I m, c ear” eliminates the display when
calling, but does not erase it from memory; only station
200canerase the NAME/NUMBERofanon-LCDstation.
SPEED DIAL MEMO
Allows an LCD user to program a 12-character name for each of his/
her 40 personal speed dial numbers. The memo pad of names may
be stepped%through to select the appropriate party. Memos may
also be added to the 40 system speed dial codes via the station
connected to port 00, station number (usually 200).
TO PROGRAM NAMES AND NUMBERS
1) Press the m fl buttons.
2) Dial the desired speed dial number.
l
The LCD displays, # * NNN SPEED DIAL.
3) Press the m button.
l
The LCD displays, # *NNN _ SPEED DIAL.
4) Enter the name or memo (refer to Recording a Message).
5) Press the m button.
l
The LCD displays, *NN MEMO SPEED DIAL.
6) Enter the desired telephone number (16 digits maximum).
7) Press the [ button to record data in memory.
TO DIAL A SPEED DIAL NUMBER
1) Press the m button.
l
The LCD displa
s, MODE NO.?
2) DialiQLl*.(QCL=
ii
I-IIorlI-om.
l
The s eed dial number apears with name or memo.
3) Press the - A
bl
button to scan the directory for the appropri-
ate number/memo.
4) Press any available
q
button.
5) The number is dialed.
NOTES:
1.
2.
3.
A station must be enabled via system programming for
LCD message memory.
Personal speed dial code numbers are 10 w 49, and
system numbers, stored from station 200 only, are 60 N
99.
Speed dial numbers and memos and their corresponding
P-digit codes may be recorded on the record sheet pro-
vided in back of this guide.
TO CHECK A SPEED DIAL NUMBER
1) Press mq 0.
2) Dial a 2-digit speed dial number (see Note).
3) If the number is longer than 16 digits, press them button
to display the remaining digits.
NOTE:
Personal (IO w 19) and system (60 m 99).
25