Filter
Top Products
GENERAL INFORMATION
GENERAL INFORMATION
BUTTON DESCRIPTIONS (continued)
DO NOT DISTURB BUTTON m
Locks the individual station in or out of the Do Not Disturb mode.
DOOR LOCK BUTTON r_inm
Controls a door lock mechanism.
HOLD BUTTON m
Holds internal or outside calls.
INTERCOM BUTTON m
Accesses an intercom line.
MESSAGE SELECT BUTTON m
Allows system and personal messages to be displayed on the
32-character Liquid Crystal Display (LCD).
MESSAGE WAITING/FLASH BUTTON m
m:
q
:
The MW/FL LED flashes to indicate a message is waiting.
Disconnects and recalls dial tone on a CO line, or is used
to access Centrex or PBX features.
q
: Also used to enter a pause or flash signal when program-
ming speed dial numbers.
MICROPHONE BUTTON m
Controls the microphone off/on while telephone is in use.
MICROPHONE CUTOFF BUTTON m
Allows astation to turn its microphoneoff/on while idle. Functional
when station receives calls; them key controls the microphone
when the station originates calls.
NIGHT TRANSFER BUTTON
q
Controls the system’s CO line ringing pattern for after hours
incoming calls.
BUTTON DESCRIPTIONS (continued)
PAUSE BUTTON m
Applies a l/2- or 2-second pause when used in programming
speed dial numbers (time is set in system programming).
PAUSE (LONG) BUTTON m
Inserts a IO-second pause when used in programming speed
dial numbers.
POOLED LINE BUTTON
q
Allows a group of CO lines to appear under one button.
PRIVACY BUTTON m (Release 3 only)
Blocks Privacy Override of CO lines from stations that have
common CO line button appearances. This button does not block
Busy and Executive Override.
PRIVACY RELEASE BUTTON m
Releases privacy on a CO line so another station can enter the
conversation.
REDIAL BUlTON m
Redials the last telephone number dialed.
RELEASE BUTTON m (Release 2 and higher)
This feature disconnects the existing call and places the station
into an idle condition, whether the electronic telephone is on- or
off-hook.
SAVE BUTTON m
Saves a telephone number after dialing and automatically redials
that number when button is pressed in the idle state.
SPEAKER BUTTON m
Turns the speaker on/off. The speaker button will also, select a
CO or intercom line if programmed for auto preference in system
programming. Also, used to disconnect when the handset is in
the cradle.
4