Filter
Top Products
REMOTEADMlN&MAlNTPROCEDURES
SECTION 200-096-600
FEBRUARY1991
TABLERM-C
PROGRAM90
INITIALIZING PROGRAMS 00 - 97
iTEP ACTION
DISPLAY/PRINTOUT
1
Enter the Program Mode
>MODE PROG
At the >MODE prompt enter 1 1 H 1
q
.
2 Enter Program Number 90
P 90
Press
q
. P90
3 To Initialize All Programs Enter 1 1 i 1 0
P90 00-97
NOTE: Single programs can be initialized by entering a single
program number plus B . Group numbers are separated by an 1 .
4 Enter key number 1 0.
P90 00-97
01 N
5 Change 01 key to “ON” by entering 1 P9O 00-97 01 N Y
6 Press m P9O 00-97 01 N Y
02 N
7
Change 02 key to “ON” by entering a . P90 (IO-97 01 N Y
02
N Y
8 Pressm . P90 00-97 01 N
Initialization complete.
02
N Y
NOTE: If program data is not entered correctly, then
q
will
P90
not respond. To retry, press F
q
.
9
Exit Program 90:
P90 #
Press njm . P
10
Enter Program 77:
P77
Press iim .
11
Press [ 0 1 P77 1 14 N
then:mm
P77 1 14 N Y
P77
12
To Exit this Program:
Press In(9 .
IMPORTANT NOTE:
If al/programs are initialized, the “IMDU enabled” has a/so been turned off in
Program W-1, LED 14.
If using the IMDU for remote programming, go into Program 77-1 and turn key/LED 14 on as shown
in steps 9, IO, and 11. If this is not completed, remote programming must be reactivated
locally
from
the programming electronic telephone.
-ll-