Filter
Top Products
REMOTE ADMIN & MAINT PROCEDURES
SECTION 200-096-600
FEBRUARY 1991
dialing codes for either an individual station, 10 0 .\,
>MODE DUMP
(all stations and system data) 1 m B (system data .’
D MSG SYS
only).
.
SYS M60 OUT TO LUNCH
9.05 LCD Messages Dump: While in the dump
SYS M61 IN A MEETING
mode, enter “MSG” and two or three characters
SYS M62 CALL
SYS M63 BACK AT
and press
q
. The characters represent stored
SYS M64 RETURN ON
messages for either an individual station, 101 (all
SYS M65
stations and system data) or 4 m H (system data
SYS M66
only). For a printout example, see Figure 4.
SYS M67
SYS M68
9.06 Tables provide a quick reference to the step-
SYS M69
by-step procedures to output the appropriate data.
D
IO TEST MODE
FIGURE 4-SAMPLE PRINTOUT OF
SYSTEM MESSAGES
10.00 General
NOTE:
10.01 The remote test mode can be used to test
Programs are output only in the groups indi- STRATA DK stations and CO line circuits from an
cated. To print out or review a program not
off-site location.
included above, use Program Mode proce-
dures.
10.02 This testing function is accomplished by
accessing stations from the remote terminal, and
9.04 Speed Dialing Dump: While in the dump
activating various buttons on the electronic tele-
mode, enter “REP” and two or three characters and
phone to make telephone calls, set function but-
press
q
. The characters represent the speed
tons, change the system time and date, etc. (see
Figure 5).
REMOTE SITE
REMOTE
PUBLIC TELEPHONE
NETWORK KSU
t\ I
TERMINAL
MODEM _
CO LINE
(300 or 1200 BPS)
REMOTE
STATION B
CO LINE
CO LINE B
I \
Electronic Telephone XX
CONNECTION
:
FIGURE 5-TEST MODE FUNCTION DIAGRAM