Filter
Top Products
FEATURE USE
FEATURE USE
MICROPHONE CONTROL
(continued)
SPEAKERPHONE
(continued)
4) Speak at a normal voice level in the direction of the
telephone.
5)
Press the m button when the call is completed to
disconnect.
TO RECEIVE AN INCOMING CALL
1,) You hear a ringing tone.
2) Leave the handset on-hook.
3) Press the w button next to the flashing red LED (CO
Incoming Call rate).
l
CO LED flashes at the In-use rate.
4) Speak at a normal voice level in the direction of the
telephone.
5)
Press the m button when the call is completed to
disconnect.
TO MAKE AN INTERCOM CALL (On-hook Dialing)
1) Leave the handset on-hook.
2) Press the m button.
l
Listen for intercom dial tone.
l
INT LED flashes green at the In-use rate.
3) Dial the desired station number.
l
You hear a single ring tone.
4) Speak at a normal voice level in the direction of the
telephone.
5) Press them button when the call is completed to
disconnect.
MICROPHONE CONTROL
The m button is used to switch the digital telephone’s micro-
phone from on to off or vice versa while the telephone is in use
(also see Microphone Cut-off- button). The red MIC LED
indicates the status of the microphone:
LED
MICROPHONE
ON ON
OFF OFF
All digital telephones can answer intercom calls handsfree (on-
hook) via the microphone, but only a speakerphone can talk
handsfree when originating CO line or intercom calls while on-
hook.
The microphone and accompanying LED are always ON when
receiving intercom calls to allow handsfree answerback, and
may be on or off when beginning to place an on-hook CO line or
intercom call.
l
Each station’s microphone may be set in system program-
ming to be on or off at the start of handsfree dialing.
l
Each station’sm button may be set in system programming
to switch on/off with one touch or to switch on/off only while
pressed.
NOTES:
1. To change from speakerphone to handset:
l
Lift handset.
2. To change from hands
l
Press and hold the
l
Return handset on-hook.
l
Release the m button.
3. The m and m buttons function on off-hook call
announce calls for privacy.
TWO (TANDEM) CO LINE CONNECTION
TO ESTABLISH A TANDEM CO LINE CONNECTION (TRK-TRK)
1) While connected on an established CO line call (incoming
button.
l
You hear intercom dial tone.
l
CO LED flashes green at the Conference rate.
l
INT LED flashes green at the In-use rate.
*
3) Access a second CO line and dial the next telephone
number.’
4)
Press the m button after the party answers.2