Filter
Top Products
FEATURE USE
FEATURE USE
NIGHT TRANSFER
PROGRAMMABLE OPTION
OVERRIDE CALLS (continued)
On an optional basis, your system can function with two or three
ringing patterns. If three patterns are selected, they are desig-
nated DAY, DAY 2, and NIGHT. If only two patterns are selected,
DAY and NIGHT designations are used.
In both cases, different ringing patterns are chosen by pressing
the
q
button. Certain CO lines may be enabled in system pro-
gramming to switch from normal operation to DISA line opera-
tion.
The active pattern is shown by the state of the NT LED as follows:
DAY
DAY 2
NIGHT
Three-pattern
OFF
FLASH
ON
Two pattern
OFF
N/A
ON
OVERRIDE CALLS
TO INITIATE A BUSY OVERRIDE SIGNAL
After reaching a busy station, you may signal that station that a
call is waiting by dialing 1.
l
A tone signal is heard at the busy station.
NOTE:
If the Off-hook Cal/Announce option is installed on the busy
stat@, then you may talk.
TO OVERRIDE DND (Programmable Option For Selected
Stations)
After retiching a DND station, you may signal that station that a
call is waiting by dialing 1.
l
A tone signal is heard at the DND station.
TO INITIATE EXECUTIVE OVERRIDE (Programmable Option
For Selected Stations)
After reaching a busy station, Executive Override allows you to
enter an established conversation by dialing 1.
l
An optional tone signal is heard by the called parties prior to
entering the conversation.
NOTE:
Privacy override and off-hook call announce are in a
separate section of this guide; see the index.
SPEAKERPHONE
TO MAKE AN OUTSIDE CALL (On-hook Dialing)
1) Leave the handset on-hook.
2) Press any available
q
button (or them button + access
code).
l
Listen for dial tone.
l
CO LED flashes at the In-use rate.
3) Dial the desired telephone number.
4) Speak at a normal voice level in the direction of the
telephone.
5) Press the m button when the call is completed to
disconnect.
TO RECEIVE AN INCOMING CALL
1) You hear a ringing tone.
2) Leave the handset on-hook.
3) Press them button next to the flashing LED (CO Incoming
Call rate).
l
CO LED flashes at the In-use rate.
4) Speak at a normal voice level in the direction of the
telephone.
5) Press the m button when the call is completed to
disconnect.
44
45