Filter
Top Products
FEATURE USE
FEATURE USE
MESSAGE WAITING
MESSAGE WAITING (continued)
If someone calls your telephone and you are unable to answer,
the calling party may set the Message Waiting indicator (a
flashing LED) on the called party’s telephone.
The Message Waiting indicator is the MW/FL LED on the IO- or
20-button electronic telephone.
Up to four Message Waiting indications may be queued on the
message indicator at one time. One of the four message indica-
tions is always reserved for the Message Center; the other three
may be set from any other telephone or voice mail device.
The button associated with the message indicator on the lo- or
20-button telephone is shown as MW/FL.
TO ANSWER A MESSAGE WAITING INDICATION ON YOUR
TELEPHONE
1) If the MWIFL LED is flashi
handset, press the m and
ur telephone: Lift the
buttons, respectively.
l
This calls the station that set the message indicator.
l
Wait for an answer to receive the message.
NOTE:
If there is no answer, hang up and try at a later time (the
MW/FL LED continues to flash).
2) After receiving the message, place the handset on hook.
l
If the MW/FL LED turns off, you have no more mes-
sages.
0. If the MW/FL LED continues to flash, you have more
messages-repeat steps 1 and 2 to retrieve them.
l
If the flashing message LED was turned on by a voice
mail device, the device will cancel the indication after
a short delay. The cancel time depends on the voice
mail device’s parameters.
NOTE;
our telephone does not have a m button, dialm
TOSETTHEMESSAGEWAlTlNGINDlCATORONANOTHER
TELEPHONE
1) At yourtelephone: Lift the handset, press them button and
dial the desired intercom number.
2) If the called telephone does not answer: Press them
button to set the message indication (or dial I).
l
The MW/FL LED flashes at the called telephone.
l
The MW/FL LED illuminates steady at your telephone.
3) Place the handset on-hook.
l
The MW/FL LED flashes at the called telephone.
l
The MW/FL LED turns off at your station.
e The MW/FL LED continues to flash at the called
telephone.
TO CANCEL THE MESSAGE WAITING INDICATION SET
FROM YOUR TELEPHONE
Lift the handset, dial the intercom number of the telephone that
has the message indication, and press them button twice
(or dial 10).
TO CANCEL THE MESSAGE WAITING INDICATION SET ON
YOUR TELEPHONE
1) Answer the Message Waiting indication and receive the
message.
NOTE:
Thecalledpartymustanswer(off-hookorm button) for
the message indication to be canceled.
. . . or. . .
2) Press them button (do not press them button first).
NOTE:
If your telephone does not have a m button, the
message indication can be canceled by dialing m a m 1.
42
‘.
. . . .
I.._
43
/’