Filter
Top Products
FEATURE USE
FEATURE USE
OUTSIDE CALLS OUTSIDE CALLS (continued)
TO MAKE AN OUTGOING CALL (DirectAccess)
1) Lift the handset.
2)
Press any available
q
line button (or
q
button).
l
Listen for dial tone.
l
CO/PL LED flashes green at the In-use rate.
3) Dial the desired telephone number.
4) Hang up when the call is completed.
TO MAKE AN OUTGOING CALL (Dial Access)
1) Lift the handset.
2) Press the m button.
0 Listen for intercom tone.
l
INT LED flashes green at In-use rate.
3) Dial CO line access code’
.
l
Listen for CO dial tone.*
4) Dial desired number.
5) Hang up when the call is completed.
NOTES:
1.
Dial1 to access the genera/group or to use Least Cost
Routing; or dial 0 and a CO line number fi 0 w B B,; or
dial0 0 w 11 to access line group I w 8, respective/y.
2. CO dial tone is not returned when dialing via LCR, dial
1; intercom dial tone may be returned, depending on
system programming.
TO RECEIVE AN INCOMING CALL
1) You hear a ringing tone.
l
‘CO LED flashes red at the CO Incoming Call rate.
2) Press (9 line button and lift the handset.
l
CO LED flashes green at the In-use rate.
3) Hang up when the call is completed.
TO RECEIVE INCOMING CALLS WITH POOLED LINE
BUTTON
1) Ringing tone is heard.
l
PL LED flashes red at the CO Incoming Call rate.
2) Lift the handset or press the
q
button.
l
PL LED is on steady green.
3) A muted ringing indicates a new incoming call, or recall.
4) Transfer the present call or place it on hold.
5) Press and release the hookswitch to answer the next call.
6) Repeat steps 4 and 5 until all calls are completed.
7) Hang up.
NOTES:
1. A transfer to a busy station willautomatically Camp-on.
2. If step 5 is performed before step 4, the current call is
terminated.
ON-HOOK DIALING
TO MAKE AN OUTSIDE CALL
1) Leave the handset on-hook.
2) Press any availablem line button (arm button) and listen
for dial tone, or follow previous directions for Dial Access.
l
LED flashes green at the In-use rate.
3) Dial the desired telephone number.
4) Lift the handset when the distant party answers.*
5) Hang up when the call is completed.
TO MAKE AN INTERCOM CALL
1) Leave the handset on-hook.
2) Press the m button.
l
INT LED flashes green at the In-use rate
3) Dial the desired station number.
l
You hear a single ring tone.*
4) Lift the handset to converse.
5) Hang up when the call is completed.
*If busy tone is heard, press the m button to dis-
connect.
10
\ i
\\ :’
11