Filter
Top Products
nal or PC (as described in Paragraph 5). It must
interface with the public telephone network and be
compatible with Bell 103 or 212 modem specifica-
tions.
6.10 Set-up
6.11
Refer to Figure 1 and verify that the remote
terminal is connected and set-up as follows:
1) Connect the terminal and modem together
with the RS-232 cable.
NOTE:
If a personal computer is being used, connect
the cable to the serial “C0M”pot-t.
2)
3)
4)
5)
Connect the modem line input to a CO/PBX
line for access to the public telephone net-
work.
Set the terminal and modem baud rate to
match the PIOU(S) setting.
Set the terminal and modem for “Full Duplex”
operation.
Set the terminal parameters to:
Word length: 7 bits
Stop bits: 1
Parity: Even
6.20 Remote Operation
6.21 Automaticconnectionviaringingassignments:
To establish communication between the remote
terminal and the IMDU, call the number of the
system CO line assigned to ring the IMDU via the
remote terminal/modem set-up:
1) Observe the following:
l
When the CO line rings-in, it will connect
to the IMDU and the IMDU will respond by
returning modem tone to the remote mo-
dem.
l
The remote modem will return modem
tone to the IMDU and communication will
be established.
l
When communication is established, the
terminal will display: CONNECTED or
COMMUNICATIONS (see Note).
REMOTEADMlN&MAlNTPROCEDURES
SECTION 200-096-600
FEBRUARY1991
2) To continue, enter the security code per Para-
graph 6.30.
6.23 Manual connection via call transfer!
1)
2)
3)
4)
Using a telephone (at the remote location) that
can switch to the terminal/modem, dial the
number of a system CO line.
When the call is answered, request that it be
transferred to station 19 (the IMDU).
After the call is transferred
tion is established with the
call from the telephone to
dem.
Observe the following:
and communica-
IMDU, switch the
the terminal/ma-
l
When the CO line is transferred, it will
connect to the IMDU.
l
The IMDU and the remote modem will
respond to each other with modem tone
and communication is established.
l
When communication is established, the
terminal will display: CONNECTED or
COMMUNICATIONS (see Note).
NOTES:
1. If the connection is not completed or com-
munication is unsuccessful, the remote
terminal will display: NO CARRIER.
2. If this is the case, check that the equip-
mentisinstalledperParagraph5.70or6.10
of this section and try again.
6.30 Operation
6.31 Once communication is established between
the remote terminal and the IMDU, follow the steps
below to enter the security code and receive the
MODE prompt.
NOTE:
Hereafter, whenever the term
q
is used, it
means the return or enter kev. deoendina on
the keyboard being used. m mean; the
space bar. An empty square indicates one of
several characters will appear in that location
(either on the terminal’s screen or in a print-
out).
I
1) Set the keyboard for ‘Caps Lock” on.
-5-