Filter
Top Products
REMOTE ADMIN & MAINT PROCEDURES
SECTION 200-096-600
FEBRUARY 1991
LOCAL
TERMINAL
PPTC
MODULAR TO DB25
/
ADAPTOR
RS-232
I
(300
OR 1200 PBS)
I
50‘ FEET MAX. 24 AtiG
KSU
.
_ p’ou(s) INTERNAL
See Peripherals Installation, Section 200-096-208,
for detailed pin-out information.
5.20 Local Operation
5.21
Use the procedure below to establish com-
munications between the local terminal and the
PIOU(S) so that programming may be accom-
plished via the terminal.
NOTE:
Hereafter, whenever the term
q
is used, it
means the return or enter key, depending on
the keyboard being used. m means the
space bar. An empty square indicates one of
several characters will appear in that location
(either on the terminal’s screen or in a print-
out).
1) Set-up the terminal as described in Paragraph
5.10.
2) Set the terminal to on-line.
3) Set “Caps Lock” on (upper case).
4)
Press
q
key.
l
The system responds, and the terminal
displays:
* DKTS VERSION 1.0 or DK CONNECT
t-1
> CODE
5) Type the 4digit security code, and press
q
.
l
The system responds, and the terminal
displays:
OK
MODE
NOTE:
The security code can be entered any time the
CODE prompt appears.
6) To continue, go to Paragraph 7.
6 REMOTE TERMINAL SITE
6.00 Requirements
6.01 Terminal:
The terminal must interface with
an asynchronous modem, communicate in ASCII
code at 300 or 1200 bps, have a standard type-
writer-type keyboard, and display data via a CRT
display or printer. A personal computer capable of
emulating the described terminal may also be used
(see Figure 1 and Paragraph
15).
6.02
Modem:
The modem must be full-duplex
asynchronous, operate at’ 300 or- 1200 bps and
have an RS-232 interface to connect with a termi-
-4-