Filter
Top Products
FEATURE USE FEATURE USE
MESSAGE WAITING (continued)
has the message indication, and pressthe-buttontwice
(or dial 1 I).
TO CANCEL THE MESSAGE WAITING INDICATION SET ON
YOUR TELEPHONE
1) Answer the Message Waiting indication and receive the
message.
OVERRIDE CALLS
NOTE:
The called party must answer (off-hook or m
button) for the message indication to be canceled.
or .
2) Press the B button (do not press the m button
first).
NOTE:
If your telephone does not have a DXa button, the
message indication can be canceled by dialing m 111.
NIGHT TRANSFER
PROGRAMMABLE OPTION
On an optional basis, your system can function with two or three
ringing patterns. If three patterns are selected, they are desig-
nated DAY, DAY 2, and NIGHT. If only two patterns are selected,
DAY and NIGHT designations are used.
In both cases, different ringing patterns are chosen by pressing
the
q
button. Certain CO lines may be enabled in system pro-
gramming to switch from normal operation to DISA line opera-
tion.
The active pattern is shown by the state of the NT LED as follows:
Three-pattern Two pattern
DAY OFF OFF
DAY 2 FLASH N/A
NIGHT ON ON
TO INITIATE A BUSY OVERRIDE SIGNAL
After reaching a busy station, you may signal that station that a
call is waiting by dialing 1.
l
A tone signal is heard at the busy station.
NOTE:
If the Off-hook Cal/Announce option is installed on the busy
station, then you may talk.
TO OVERRIDE DND (Programmable Option For Selected
Stations)
After reaching a DND station, you may signal that station that a
call is waiting by dialing B.
l
A tone signal is heard at the DND station.
TOINITIATE EXECUTlVEOVERRlDE(ProgrammableOption
For Selected Stations)
After reaching a busy station, Executive Override allows you to
enter an established conversation by dialing 1.
l
An optional tone signal is heard by the called parties prior
to entering the conversation.
NOTE:
Privacy Override and Off-hook-Call Announce are de-
scribed in separate sections of this guide and are listed in
the index.
SPEAKERPHONE
(DKT 1020SD ONLY)
TO MAKE AN OUTSIDE CALL (On-hook Dialing)
1) Leave the handset on-hook.
2) Press any available
q
button (or them button + access
code).
l
Listen for dial tone.
l
CO LED flashes green at the In-use rate.
3) Dial the desired telephone number.
\: ,.i
/
47