Filter
Top Products
INSTALLATION-WIRING DIAGRAMS
SECTION 200-096-209
FEBRUARY 1991
‘-
TO PESU W/FEMALE
CONNECTOR
R2SIDGING CLIPS
STATION CABLING JACKETED TWISTED PAIRS (24 AWG)
=;
TIP 1
RING 1
I?
RJll
TIP
db
RING
--
Ii---z- !
1 CIRCUIT 3
US54321 u
Two-ringers max may be
connected (high or low)
to Tip/Ring.
--- -1
VOICE Tl (VT) 5
18 VOICE RI (VR) 5
191 DATA Tl (DT) 5
DATA Rl (DR) 5
-
-
-
DR
5-k
-
III
BK-GNI 38 &
OCAT #(IIIIBL
” ,III,,
OT AND OR:
I I I I I I
654321
ONLY IF
ELECTRONIC
-
2 GN-BKI 13 &
TELEPHONE
RECEIVES
n
m I”’ lClRCUlT8TO
OFF-HOOK CALL
STATION
ANNOUNCE CALLS
ELECTRONIC TELEPHONE
’ hn HDCB
I “T(
SFF
GN-Y I 18
--
II ! I I I
VVJ b/u I ,r n&B IS CONNECTED TO CIRCUIT 5
Dnn D’h’c ‘IA’ TAGE OPTION (CIRCUIT 1 & 2):
J 1
XVEL (13OV P-k)
H = HIGH LEVEL (19OV P-P)
J
NOTES: (Electronic telephone circuits 5-8)
1. To receive OCA, the 6500-series electronic telephone
must have HVSI and HVSU installed.
2. Program 31, button/LED 03 must be “on”for
electronic telephone to receive OCA.
3. An HHEU must be installed inside 6500series electronic
telephones for headset or HESB; loud bell option.
4. All cable 24 A WG. max 40 ohm looo resistance
LV-BR ! 49 ;
from PESlJ to electronic telephone’(1000 ft).
5. DSS connection is not available with PESU; HDCB may
be connected to circuit 5, BGM to circuit 8, slot 1.
66M150
SPLIT BLOCK
NOTES: (Standard telephone circuits 1 & 2)
1. All cable 24 A WG; max loop resistance 300 ohms from PESU to standard telephone/VM port.
2. Standard telephones may be on- or off-premises. Off-premises connection is made via
OL 13A FIG, and RJ21 X jack.
3. Two ringers max per port.
FIGURE 9-8-PESU CIRCUIT CARD WIRING DIAGRAM
9-10