Filter
Top Products
SPEED DIAL MEMO (continued)
MESSAGE SENDING
TO CHECK A SPEED DIAL NUMBER
1) Press m 1.
2) Dial a 2-digit speed dial number (see Note).
3) If the number is longer than 16 digits, press them button
to display the remaining digits.
NOTE:
Personal (10 w 19) and system (60 w 99).
TIMED REMINDERS WITH MEMO
Allows five separate messages to be set at each LCD station. These
messages will be displayed at the times (hour and minute) set by the
station user. They can either be displayed just once or repeated on
a daily basis.
TO SET A TIMED REMINDER WITH MEMO
1) Press the m button.
2) Dial a 3-digit reminder number (11 m N 1 i 1).
3) Enter the desired time (24-hour clock format; i.e., HHMM) for
the message to be displayed.
4) Dial 1 if the message is to be repeated every day, or fl if it is
a one-time message only.
5) Enter the desired message number.*
6) Press the 1 button to record the data in memory.
0 Listen for confirmation tone.
l
The message will be displayed at the specified time, and
a beeping tone will be heard for 30 seconds (or until it is
canceled by pressing the m button).
* Personal (10 w 19) and system (60 m 99). The message does
not display when setting a timed reminder-it displays when
the remjnder activates. Messages are set using the Record
a Message method.
The Alphanumeric Messaging feature on your LCD electronic
telephone enables you to set short text (up to 32 characters) at your
station to ensure that you do not miss important calls. Any station
may record a message; however, only stations with the LCD are
able to display messages. To record messages, see the message
administration functions in this guide.
Your system has up to 40 preprogrammed messages that may be
sent to other LCD electronic telephones. You can temporarily add
to or change any of these messages, in order to leave a personal-
ized message at your station (see Note).
Some stations may record and save up to 10 personal messages to
be used for all types of station messaging. This is a station option
that is enabled in system programming.
NOTE:
Storedmessages and their corresponding message number(s)
may be recorded on the record sheet provided in the back of
this guide.
CALLED STATION MESSAGING
Your station number and a message indication may be sent to
another LCD station. When that station responds, it will receive the
message.
TO SET A CALLED STATION MESSAGE
1)
2)
3)
4)
5)
6)
Dial the station number (station does not answer).
Press the m button.
l
The LCD displays, MODE?
Dial 1.
l
The LCD displays, MW TO STNNN MSG NO?
Enter the desired message number.*
l
The LCD displays, INT NNN MW SET.
Press the m button to release.
!6
27