INSTALLATION-PERIPHERALS
SECTION 200-096-208
FEBRUARY1991
mode). PC 2 can now issue AT com-
mands to PDIU-DS 204.
l
If PDKWPDIU-DS port 04 is the only
PDIU port connected to a modem
(Pro-
gram
20, LED 03 ON), then the MODEM
LEDs on all DKTs will light.
4) From PC 2’s keyboard, type~~~~~~~and
press= (AT commands must be capital
letters); this prompts PDIU-DS (204) to dial
and connect to PDIU-DI (200).
l
The CONNECT LED on the PDIU-DS
(204) will be lit; the DATA and MODEM
LEDs on DKT 200 will also be lit.
l
The screens on PC 1 and PC 2 display,
CONNECT XXXX, where XXXX is the
data transmission speed set by the com-
munication software.
l
At this time, PC 1 and PC 2 are con-
nected, as shown by the thick lines, to
exchange data (file transfers, typed mes-
sages, etc.).
5) To terminate the call:
a) Type [I 1 from either PC keyboard.
l
The PC screen displays, OK.
b) ~w000f
rom the PC keyboard used
in step 5a.
l
PC 1’s and PC 2’s screens both dis-
play, NO CARRIER.
l
The DATA and MODEM LEDs on
DKT 200 will turn off.
-.\,
.I
,
,
..’
8-60