Filter
Top Products
PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECORDS
SECTION 200-096-302
FEBRUARY1991
I
Privacy Override. Privacy Override of DISA
two-CO line calls is not allowed.
NOTES:
1. To configure the DK system to operate as
nonpriva te, allow privacy override from all
stations.
2. Privacy override can be blocked by a
station via the PRIVACYbutton (Program
39) or by the executive/privacy blocking
option (Program 31, LED 18).
3. See Table 2-C at the end of this chapter.
l
Executive Override, LED 18-Executive
Override allows a station to break into and
overhear an existing station conversation
by dialing the digit 1 after the busy station
number. A warning tone may be set option-
ally-see Program 1 O-2. The option is for
which calling station can use Executive
Override.
NOTE:
Executive override can be blocked by sta-
tions that have executive/privacy blocking
enabled in Program 37, LED 18; the m
m button does not block executive over-
ride. See Table 2-C at the end of this chapter.
l
DND Override, LED 17-An electronic or
digital telephone can have a button pro-
grammed for Do Not Disturb (DND). When
called, a station with DND activated will
return very fast busy tone (four tones per
second). If the caller presses the additional
digit 1 on the dial-pad, a DND Override
tone will be heard on the called station’s
speaker. Theassignment isforwhich calling
station can use DND Override.
l
Toll Restriction Traveling Class Code
Change, LED 16 (Release 3)-If this LED
is lit for a port, the station occupying it can
change the 4-digit Toll Restriction Travel-
ing Class of Service Codes established in
Program 44B. Stations selected for this
feature must follow the dialing sequences
below to change the codes:
Class 1: m + ~~ I+ the 4-digit code + i
or=
Class 2: m + III+ the 4-digit code + 1
or=
Class
3: m + III+ the 4-digit code + $
or=
Class 4: m + i Ii+ the 4-digit code + 6
or=
l
Verified Account Code Change, LED 15
(Release 3)-If selected for this feature, a
station can change the Verified Account
Codes established in Program 69. Se-
lected stations must dial the the following
sequence to change the codes:
~+~II]~+~~~-B~~+Verified
Account Code + 6 or m
l
Verified Account Code, LED 14 (Re-
lease 3)-If this feature is selected, all
account codes (forced or voluntary) dialed
by the station will be verified per account
codes set in Program 69. If the station user
fails to dial one of these specific verified
account codes, the call cannot be executed
(forced), or the account code will not be
validated for the SMDR call report (volun-
tary).
l
Handset Volume Level, LEDs 12 and 13
(Release 3)-This program sets for each
digital telephone the handset’s initial off-
hook volume level. This level can be
changed with the digital telephone’s
volume control button while the handset is
off-hook, but it will return to the default level
set in this program after the handset is
placed on-hook.
l
The volume level range for digital tele-
phone handsets is 1 N 9, with 1 as the
lowest. Anytime a handset is off-hook, its
volume level can be adjusted anywhere
between 1 y 9. The level setting estab-
lished in this program, however, can only
be from 2 w 5. This level is set with LEDs 12
and 13:
For level 5: Both LEDs ON (High)
For level 4: LED 12, OFF; LED 13, ON
For level 3: LED 42, ON;- LED 13, OFF
(Initialized setting)
For level 2: Both LEDs OFF (Low)
,
2-10