Filter
Top Products
CALL FORWARD DISPLAY
(continued)
NOTES:
1. Tocance/ca//forward,press~~~~~ (orpress
the call forward button used to set call forward).
2. If call forward is set:
l
CO lines that ring at your station only will forward (CO
lines that ring into more than one station willnot forward).
l
CO line calls transferred to your station will forward.
l
Intercom calls will forward.
l
Call forward redirects the station hunt feature.
STATION-TO-STATION MESSAGE WAITING
TO USE STATION-TO-STATION MESSAGE WAITING
1)
2)
3)
4)
5)
Lift the handset.
Dial the desired station number.
l
If there is no answer (busy or DND), press the-
button (or dial I). This causes the MESSAGE LED on the
called station to flash.
l
The called station’s LCD displays the calling station’s
number.
The called station user presses the m and B
buttons to return the call.
To clear the MESSAGE LED from the called station, press the
B button.
To clear the MESSAGE LED from the calling station, press the
m button, dial the station number and press the Dam
button twice (or 0 B.
NOTE:,
Up to four message waiting displays may be stored on the
LCD. Thestationnumberin theleft-mostposition willbecalled
n is pressed. To rotate the station
button. The fourth message is re-
served for the Message Center.
VOICE MAIL (VM)
Whenever your station is call forwarded to voice mail, certain digits
will automatically be sent to the voice mail unit to
direct the call to
your mailbox.
TO STORE THE DIGITS TO BE SENT
1) Press the m button.
2) Dial 111.
l
The LCD displays, 6 5 6 ID CODE SET.
3)
Dial the digits (up to 16) and pauses (B to be sent.
l
The LCD displays the digits and pauses.
4) Press the 1 button to store data.
l
Listen for confirmation tone.
When you want to retrieve your messages from voice mail, certain
digits will automatically be sent to the voice mail unit to
play back
your messages.
TO STORE THE DIGITS TO BE SENT
Press the m button.
Dial 110.
l
The LCD displays, 6 5 7 ID CODE SET.
1)
2)
3)
4)
Dial the required digits and pauses to be sent.
l
The LCD displays the data as it is entered.
Press the 1 button to store data.
l
Listen for confirmation tone.
TO RETRIEVE MESSAGES
Press the m and B buttons.
TO CLEAR ALL DIGITS
1) Press the m button.
2) Dial~~~or~~~.
3) Press the 1 button.
NOTES:
1. The above procedures are required for initial VM set-up
only. The digits remain in memory until changed.
2. Digits are not sent to camped-on VM calls.
14
15