Filter
Top Products
PROGRAMMING
PROCEDURES-INSTRUCTIONWSYSTEMRECORDS
SECTION 200-096-302
FEBRUARY1991
PROGRAM00
‘\
SOFTWARE CHECK/REMOTE MAINTENANCE SECURITY CODE ASSIGNMENTS
.
SELECT = Select Code
Enter 0 to check S/W version.
Enter 1 to change 1st level password.
Enter 2 to change 2nd level password.
Enter 8 to check software sum.
Enter 9 to check counter.
Password Codes
Enter the 4-digit password.
See Note 3.
Select
Code
0
1
2
8
9
NOTES:
Item
Password or S/W Check Codes
ROM Version
=
1st Level Password =
2nd Level Password =
Software RAM Checksum =
See Note 4.
Power Cycle Counter =
nnnmn See Note 5.
1. See instructions in Table 1 -F (Section 200-096-301) to program the system
with this information.
2. Initialized passwords are 0000.
3. The LCD responds as follows, when a selection is made:
0 Version =
1 Password =
2 Password =
8 Sum=
9 Counter =
4. This selection is not programmable. It identifies the system’s software
version as follows:
LEIIIU
LEl~~00
STRATA DK IT T I ROM Version 7 I ROM Version
L X = PCTU, V = PCTUS
L PCTU3
DX = Release 1 (RI) software (PCTUI)
DX = Release 2 (R2) software (PCTUZ)
DV = Release 2 (R2) software (PCTUS)
PCM = Release 3 (R3) software (PCTU3)
5. These selections are not programmable. They are for factory test purposes
on/y. The Checksum and Counter vary as customer data is entered.
2-50