Filter
Top Products
REMOTE ADMIN & MAINT PROCEDURES
SECTION 200-096-600
FEBRUARY 1991
TABLE RM-2
PROGRAM 60
SMDR OUTPUT/ACCOUNT CODE DIGIT LENGTH
iTEP
ACTION
DISPLAY/PRINTOUT
1 Enter Program Mode
>MODE PROG
At the >MODE prompt, enter u a m m
q
P
2 Enter Program Number 60
P 60
Press
q
P60
3
Allow SMDR printout on incoming and outgoing calls. P60 3 1
Enter: Action code 3.
P60
System will print out “1” if incoming and outgoing calls will be
printed on SMDR. A “0” will be printed out if only outgoing calls
will be printed.
Refer to the System Record Sheet and change (to 1 or 0), if
required, and press
q
.
4A
Set Account Code Digit Length
P60 4 06
Enter: Action code 4.
The system will display the number of digits allowed in the
account code. The default is 06.
Refer to the System Record Sheet and enter the required number
of digits (04 - 15).
4B
SMDR Toll Calls Only
P60 5 0
Enter: Action code 5.
The system will display the presently selected feature (0 - 5).
The default is 0. Refer to the System Record Sheet and enter the
required feature code.
4C Enter DISA ID Code
P60 6 -
Enter: Action code 6.
System will display last entered ID code number. Default = Blank.
5 To Exit Program/Store Data
P60 6 NNNN
A) To store data, press
q
.
B) To exit this program, press1 1
q
.
P60 ##
P
NOTE:
Programs 77-I & 77-2, use Type I procedure.
. .
-3o-