Filter
Top Products
FEATURE USE
CALL HOLDING (continued)
EXCLUSIVE HOLD (continued)
NOTE:
NOTE:
Regarding handsfree answerback,
an
intercom call must
be answered by pressing the m button or lifting the
handset before it can be placed on hold.
TO HOLD/PARK A CALL AND PLACE ANOTHER CALL (CO
line does not appear on your station)
When a CO line is placed on Exclusive Hold, it may be
picked up at another station by dialing a and the station
number that placed the call on Exclusive Hold; however it
cannot be picked up by pressing a common (9 button at
another station.
1)
2)
3)
4)
While connected to a CO or intercom call press the
m button and dial fl .
To make another call, press the
I&
or a[9 button and dial
the desired number.
Hang up or press the m button when the call is com-
pleted.
To retrieve the held call made in step 1, press them button
and dial 15 (see Note 3).
NOTES:
1.
2.
3.
The on-hold recall tone will be heard within a predeter-
mined time.
The heldcallmaybe releasedautomaticallyif the other
party hangs up (if the CO provides a hold-release
signal).
When a CO line is placed on hold, it may be picked up
from any station:
l
Press a 0 button with common appearance.
%
l
Press the button and dial I+ N (N = the holding
station’s intercom number).
l
Press the m button and dial 11 + N (N = the
’ holding CO line’s number-O 1 w 36, Release 2 and
higher).
EXCLUSIVE HOLD
TO USE EXCLUSIVE HOLD (CO line must appear on your
station)
While connected to an outside call, press them button twice.
l
CO LED flashes at a fast (10 IPS) rate.
l
To reconnect the call, press the CO button that is on hold.
CALL PICKUP
TO PICK UP RINGING CO LINE (Tenant l/Tenant 2 Line
Groups)
Press them or= button (or press them button and
dial 11).
TO DIRECT PICK UP ONE OF THE FOLLOWING
1) Station: Press the m button + station number (inter-
com, ringing or held CO line).
2) Intercom Page: Press the m button + 11.
3) External Page: Press the
l
4) CO line on hold: Press the
q
Kn”$!~(OO=CO
line number: 01 u 36, Release 2 and higher).
5) Any ringing CO line: Press the m button + m .
NOTE:
Ifa
button is not available, press m + 1 instead of
the button.
DO NOT DISTURB
Allows you to prevent incoming calls from accessing your station.
You can still make out-going calls.
TO USE DO NOT DISTURB MODE
Press the m button.
l
DND LED goes on.
30
. . .
‘. ,_’
31