Filter
Top Products
PROGRAMMINGPROCEDURES-INTRODUCTION
SECTION 200-096-301
FEBRUARY1991
TABLE14
PROGRAM90
.
INITIALIZING PROGRAMS 00- 97
Press...
See Program 90System Record Sheet
Step m + LED keys
#
Action description LCD RESPONSE . . .
1. Use the programming LCD electronic or digital telephone
with programming template connected to port 05 - circuit 6.
NO.
205
JAN 20 SUN
06:30
2. ImEW
PROGRAM MODE
Enter programming mode.
3.
~~~~
Access Program 90. System beeps after m
PROGRAM = 90
DATA STORE
button is pressed to indicate the program number
can be entered.
4. m
Prepare system for the programs to be initialized.
90 SELECT =
5. 11110 +LEDkeysOl &02
Enter program numbers individually or in a range.
For a range, separate the low program number and
the high program number with an asterisk.
90 SELECT = OO"97
DATA CLR
6. m
90 SELECT = 00*97
Secure data in system programming. LEDs 01
DATA PROGRAMMED
and 02 flash.
7. m
90 SELECT =
Prepare system for another selection (go back to
step 5), or exit Program 90 (continue with step 8).
8. [[m
90 SELECT = ##
Secure Program 90 data in system memory.
DATA PROGRAMMED
9. m PROGRAM =
Exit Program 90. Enter another program number (see
Table D), or exit programming mode (go to step 10).
System beeps to indicate it’s exiting Program 90.
10.
mm
NO.
205
Exit programming mode.
JAN 20 SUN
06:42
NOTE:
The system will not allow the m
LED to light to reenter the programming mode.
11.
If all programs or just Program 32 were initialized above,
POWER OFF for 5 seconds then POWER ON.
This resets Station 205 auto preference to select
intercom when m key is pressed.
I
IMPORTANT NOTE
Always initialize Programs 00 w 97 when installing a PCTU that
is being installed for the first time for a particular configuration.
1-7