Filter
Top Products
PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 200-096-302
FEBRUARY 1991
PROGRAM 04
PORT/STATION NUMBER ASSIGNMENT
SELECT = Port Number
INT = Station Number
80
81 82 83 84 85 86 87 88 89 90 91 92 93 94 95
NOTES:
1. Follow instructions in Table I-G (Section 200-096-301) to enter this data.
2. Shaded portions of the table are for configuration purposes only.
3. If a station number is assigned, and ‘ERROR”displays on the LCD, the station number has already been assigned to another port.
4. Station numbers default to 200 - 295. New station number assignments willnot activate on individualstation LCDs until the handset
goes on/off hook.
5. If an assigned station number conflicts with a default feature access code, no error message is issued. The stations LCD reflects
the conflicting number. When another station attempts to dial the number, the station will not ring. Instead, the feature activates.
6. If station numbers that conflict with feature access codes must be assigned, use Program 05 to change the access code first.
7. The station connected to port 05 has exclusive ability to program the system.
8. PEKU ports 04, 12,20 and 28 may be configured to support Door Phone Control Boxes (HDCBs). See Program 77-l.
9. Door phone and modem (IMDU) station numbers are pre-assigned as follows:
IMDlJ modem number:
l
Modem= 19
Door phone numbers: . Port 04 = 151, 152, 153; Port 12 = 154, 155, 156
Port20= 157, 158, 159; Port28= 161, 162, 163
10. To insert a blank, press LED key 0 1; range programming is possible.
11. PEKU circuit 3 or PESU circuit 8 is the optional BGM connecting port circuit. This BGM PCB must be installed in slot 01 in Release
2, but can be in any slot with Release 3 (see Program 19).
12. Port 99 = DISA COS port (Release 2); DISA Port 99 is normally used in Program 40,41, and 48.
13. May be used to connect two-CO line external conference amplifier (customer-supplied) to PEKU PCB (see Program 10-3).
14. Last port available when using PCTUS control PCB.
15. PDKU requires Release 3 (PCTU3).
16. DlUs can be connected to ports associated with PDKU circuits 1 - 7.
I
2-51