Filter
Top Products
PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 200-096-302
FEBRUARY 1991
PROGRAM 39
FLEXIBLE KEY ASSIGNMENT REFERENCE GUIDE
l_el-i~lool-I-IS~~-~-~~n~-I-~.
SELECT = Port Number
7 / c,L. ~~
or range. See Note 4.
Press LED key to be
defined. See tables
Enter the appropriate code that corresponds
on the following pages.
to the feature to be assigned. See the
feature code reference table below.
Forwards calls to selected
Releases data call
NOTES:
1. For more information,
record sheets.
see the instructions preceding the
Key
Name
Abbrv. Code Notes
Door Lock 1 thru DRLKl
Door Lock 4
!
DFiLK2 73
II 72
Momentarily unlocks door
(HDCB 1 - 4, DRLKB 74 (3 or 6 sec.).
See Prog. 77,
W
DRLK4 75 and 77-2.
Intercom
INT 00 Intercom line access key
LCD Message MSG 81
Begins LCD message
selection
Message Waiting
and Flash
MW/FL 99
Provides message waiting
LED and Flash key
Microphone
cut-off
Sets microphone on/off for
MC0 88 incoming handsfree
intercom calls
Modem (R3)
Night Transfer
Tenant 1
Night Transfer
Tenant 2
MODEM 88
Used to reserve modem
in modem pool
NT1
91
Sets Tenant 1 CO
DAY/NIGHT ringing mode
NT2
Sets Tenant 2 CO
92
DAY/NIGHT ringing mode
Pause PAU
95
Sets a pause in Speed
Dial. See
Program
12-3
Pause (Long)
PAW) 93
Sets a 1 O-second pause
in Speed Dial
Pooled Line PL
61 - Multiple CO lines may
68
appear under one key
Privacy (R3) PRIVACY 53
Prevents Privacy Override
(not Ext. Over.)
Privacy Release
Redial Last
Number (1 key)
PRV 79
Changes station Privacy
RLS
mode to Non-private for CC
RDL 96
Redials the last
number
Release (R2)
Save Last
Number
Speed Dial
Select ([ key)
RLS 76
Releases current call
and makes station idle
Saves last number dialed
SAVE 85
for future speed dial
SDS 97
Begins speed dial
selection
Speed Dial
Speed Dial
(Fixed)
Tone
SD
*10- Reserves key for
*49 station speed dial
SD(F) **“9”- $;;i$ap~ti;~or set
TONE 90
CO dial signals set to
tone or pulse
2. Complete Program 38 before Program 39.
3. Initialized data assigns keystrip pattern associated with Code 31 from Program 38.
4. Specify a range of ports by keying in
q nHnn
Lowport ’
5. IEm
\igh port
- Sets pauses in Speed Dial if telephone does not have a pause key.
-
6. m&m
Sets flashes in Speed Dial if telephone has a pause key.
- Both keys must be programmed on electronic telephone; not allowed separately. Recommended on all
7.
q
stations using voice mail, since they allow easy access of [ andi DTMF keys.
- Codes 61 .- 68 represent CO line groups 81 w 88.
- Maximum 4
q
keys per pooled line group on each station.
2-84
I