Filter
Top Products
I
PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 200-096-302
FEBRUARY 1991
PROGRAM 15
ASSIGNING DP/DTMF, TENANT SERVICE TO INDIVIDUAL CO LINES
pq-pJlr;lr;lppJyJ-pq-pl-pJ .
SELECT = Program Code 7
/
Key LEDs = CO Line
Specify
CO
lines by setting LED keys, as defined by the table below.
All L EDs with an “X” should be lit when finished.
n-hook
CO Lines 01 - 20
‘rogram
LED Status
Code
Program
(LED Keys)
ON OFF
01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 171 18 19 21
(01) (02)(03) (04) (05) (08)(07) (08) (09)(10)(11)(12)(13)(14)(15)(16)(17)(18)(19)(2~
0 (R3) AR VM Calls’
Detect Ignore
1 CO Outgoing Signal
DP6 DTMF
I
2
CO Dial Pulse Rate
(Pulse per sec.)
20 PPS 10 PPS
3 AR Hold 4
Recognize
Ignore
/ I
4
AR Timing4
Crossbar ESS (Electronic)
95 msec. 450 msec.
5
Tandem CO Line Connection Equipped5
with Station Dropout
Not Equipped
6
CO Line Tenant Assignment
Tenant 2
Tenant 1
7
Forced Account Code
Equipped Not Equipped
8
No CRCU CRCU
Operation After Flash
after flash after flash
Off-hook
Program
Code
Program
0 (R3) AR VM Calls 7
1
CO Outgoing Signal
Detect
DP
Ignore
ESS (Electronic)
450 msec.
Not Equipped
Tenant 1
I ‘I I
Not Equipped
CRCU
4 AR Timing 4
Crossbar
95 msec.
5
Tandem CO Line Connection
with Station Dropout
Equipped
6
CO Line Tenant Assignment Tenant 2
7 Forced Account Code
Equipped
I
I
8 Operation After Flash
No CRCU
after flash
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Initialized data is all L EDs OFF.
3. Shaded areas indicate that the handset must be off-hook during programming.
Program CO lines 01 through 20 with handset on-hook
Program CO lines 21 through 36 with handset off-hook
4. AR = Automatic Release signal.
This is a momentary-open of the CO line loop provided by some Central Offices. If programmed to
recognize AR, CO lines on-hold will drop when the outside party hangs up and the CO sends AR signal. Two-CO line DISA calls always
release with AR. DISA line release is not related to this program.
6, Tandem connection must be equipped for all DISA CO lines and all other lines used for two-CO line conference.
6. If a CO line is set for Dial Pulse (DP) operation, themkey must be programmed on stations that must send DTMF tones over the CO
lines
(see Program 39,
-key).
I
7. When AR is sent on a CO line call because the outside caller hangs-up, ‘D” tone will be sent to the voice mail port
(PSTu/PESU), prompting the voice mail machine to release and clear the port for another call. Detection is from VM answer to VM
hookflash; it is not in effect after the VM or auto attendant operates the hookflash to transfer the call.
2-58