Filter
Top Products
PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECOROS
SECTION 200-096-302
PROGRAM60
SMDROUTPUT/ACCOUNTCODEDlGlTLENGTH
FEBRUARY1991
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. For Selection 3, initialized data assigns SMDR output to be enabled for incoming calls that are answered.
3. For selection 4, initialized data assigns a g-digit length to all Forced/Voluntary Account Codes.
4. If PBX code is dialed, numbers dialed after the code will be checked.
5. If A/C, O/C or SPCC code begins with “Of’, “I “, or “00’; that call will print out.
6. When accessing LCR feature, all digits sent to CO will be output.
7. Programming 60-3-U (printout outgoing call only) is still available.
8. Key/LED
7 = blank, key/LED 2 = don’t
care.
9. If a security code is not programmed, outgoing CO line access via DISA will not require a security code
when dialing.
I
10. See Program 69 for verified account codes (R3).
11. Number of digits required when “0” is the first digit dialed; if this number of digits is not dialed, the system will
disconnect the call after 20 seconds. “0” is counted as a digit. Example: 0 + I + 714 + 583 - 3700 = 12
digits; 12 should be programmed as a minimum in this case.
2-99
SELECT = 3 - 6 (Item) A
Make a selection to indicate
which item is being assigned.
Select 3 for SMDR output.
Select 4 to assign Forced/Voluntary
Account code digit length, etc.
For “3” SMD~ COR = 0 or I (Data)
Enter one digit to indicate SMDR output operation.
0 = No Incoming
Record
1 = Incoming and Outgoing Record
For “4” ACCOUNT = 04 - 15
Enter the number of digits allowed
for forced/voluntary account codes.
The range is 04 - 15. Enter two digits.
For “5” TOLL DIAL
Enter one digit (the range is 0 - 5).
For “6” DATA = DISA security code; 1 -
For “7” CREDIT = Credit Card Digits; 1 -
15 digits.
30 digits
Item
Description Data
SMDR Output when a call is completed.
(SMDR COR)
3
0 = Outgoing Only
1 = Incoming and Outgoing
0
‘°Forced/Voluntary Account Code Digit
(ACCOUNT)
4
Length 04 - 15.
(Digits are verified per
Prog.
30, Key/LED 14,
III
and
Prog. 69.
Printout options
(TOLL DIAL DATA
Toll Dial = 0
17
All Calls (Note 7)
0
W 5
=
El
1 Dial “0” calls only
=
0
2 Dial “1” calls only
= 3
0
Dial “00” calls only
=
III
4 Dial “I”, “0”, calls only
=
0
5 Dial “1” or “00” calls only
DISA Security Code9 (may be changed
DATA
W’) 6
from station, per
Program 30)
[7-o
Credit card call digit length, 01 - 30 digits,
CREDIT”
(R3) 7
(see Program 43)
q III
I