Filter
Top Products
General Tests
RESTARTING THE
CONTROL UNIT
Administrative
Restart
If you are experiencing a problem not described
in
the
previous tests, or if none of the tests reveaI a specific
problem, try the following procedures before calling the
equipment supplier.
If the portion of the memory that maintains
administration
and station programming has been corrupted, the system
may act abnormally. Restarting the control unit restores
this part of the memory, which may solve the problem.
(Restating the control unit does
not
erase administration
or programmmg.)
There are two ways to restart the control unit. One is
through an administration procedure, the other is through
the control unit hardware.
To restart the system using an administrative procedure,
dial a restart code by following these steps:
1
Slide the T/P switch on the administrator/attendant
console to
P.
2
Touch Conference twice.
3
Choose the appropriate step for your console:
> On a MERLIN II System Display Console, touch
[System] , [Restart] .
> On a BIS-34D Display Console, touch Message
and dial #200.
NOTE:
When you restart the control unit by dialing a
restart code, the Auto Answer-Intercom,
Coverage Inhibit, Do Not Disturb, and Privacy
features may get turned off, even though they are
still programmed. To turn them back on, touch
the button associated with the feature.
General Tests 4-55