Filter
Top Products
Testing the System
Perform the following tests to determine that the system is
working properly. If these tests reveal any problems, refer
to Section 4, ‘Troubleshooting,” and take corrective
action
TESTING THE VOICE
To test each voice terminal jack for intercom and outside
TERMINAL JACKS
line dial tones at the control unit location, follow the steps
FOR A DIAL TONE
below. Refer to “Default Settings” on page 3-15 for an
explanation of how default line and station identifying
numbers are assigned.
Before you begin testing, follow these steps:
1
2
3
Testing for an
lntercom Dial Tone
1
2
3
Make sure the outside lines are connected to the
system.
Take your administrator/attendant console to the
control unit.
Unplug the jumper cord from the jack on the control
unit for Intercom 10 (jack location 01), and plug in the
modular voice terminal cord for the console you are
using for the test.
The red light goes on next to the third button down in the leftmost
column of buttons.
Touch the fifth button down in the leftmost column of
buttons (intercom-Ring).
The red light goes on next to this button.
Pick up the handset.
The green light next to the red light goes on and you hear an
intercom dial tone.
Replace the handset and touch the fourth button down
in the leftmost column of buttons (Intercom-Voice).
The red light goes on next to this button.
2-100 Testing the System