Filter
Top Products
5 Press the Auto Intercom button until the green light
next to the button shows the setting you want:
Studygreen light = attendant position
Flashing green light = potential attendant position
Green Iight off cannot be assigned as an attendant position
6 Press #.
The message "System is Re-starting..." appears. When the process
is complete,
after a short delay, the lights flash next to Adm Tel,
Adm Pool, Message, and Speaker.
7 Continue administration or leave administration mode
by sliding the T/P switch to the center position.
Performing Flexible Numbering
C0NSIDERATIONS
●
●
This feature can be administered only
from
a MERLIN
II System Display Console. It is available with Feature
Module 2 and Release 3, not with Feature Module L
Flexible Numbers, except for tie lines, can be one to
four digits but the first digit
cannot
be 0.
If you combine short flexible numbers with long ones,
the longer numbers cannot begin with the same digit as
the shorter ones. For example, a hotel couldn’t assign
the number 2 to the bellhop and the number 201 to
room 201 because when callers begin to dial mom 201,
they would be connected to the bellhop as soon as they
dialed 2.
For Release 3, the following numbers
cannot
be used
for flexible numbering: 7,76,77,78,760 through 783,
and 7600 through 7839. These numbers were reserved
for CMS split codes used only with FM2.
If your system is using basic telephones, you should
not use 9 or 88 as flexible numbers. If the basic
telephones are connected through a BTMI, BTMI-2, or
Administering a New System 3-25