Filter
Top Products
With a BIS-34D Console
IDENTIFING
LOUDSPEAKER
PAGE LINE JACK
1
2
3
4
5
6
Enter administration mode by sliding the T/P switch to
P.
Press
Conference
twice.
Lights flash next to Adm Tel, Adm Pool, Message, and Speaker.
Press Message.
Dial #204.
Green light nex t o Message goes on steady and two beeps sound.
Press the line button until your selection is shown:
Green light on = jack is assigned for Music-on-Hold
Green light off = jack is for a standard line or loudspeaker page
Press
Message.
Continue administration or leave administration
mode
by sliding the T/P switch to the center position.
Check Form 1e, System Form-Requirements and Options
for Release 3, or the Line Jack section of the Master
Planning Form for Feature Module 2 to see if the system
includes the Loudspeaker Page feature. If so, you need to
identify the control until line jack to which the paging
equipment will be connected. Keep in mind that the
Loudspeaker Page line can’t be placed in a line pool, used
for Music-on-Hold, or used as a DISA line.
Perform the appropriate procedure below to identify the
Loudspeaker Page line jack.
With a Display Console
1 Enter administration mode by sliding the T/P switch to
P.
2 Press
Conference
twice.
The administration menu appears.
3-46 Administering a New System