Filter
Top Products
3 Press Adm Pool.
Green light comes on steady and two beeps sound.
4 Dial the pool code.
5
Press line buttons until your selection is shown:
Red light on = line in pool
Red light off = line not in pool
6 Press Adm Pool.
7
Press Conference to continue administration or leave
administration mode by sliding the T/P switch to the
center position.
SPECIFYING TOUCH-
Refer to Form la, System Form-Incoming Lines for
TONE OR ROTARY
Release 3, or the System Configuration Form for Feature
SIGNALING
Module 2 to determine if the system contains any rotary
lines. If it does, follow the appropriate procedure below:
With a Display Console
1
2
3
4
5
Press
[Lines], [More], [TchTone].
Enter administration mode by sliding the T/P switch to
P.
Press
Conference
twice.
The administration menu appears.
Press the line buttons until your selection is shown:
Green light on = Touch-Tone signaling
Green light off= rotary signaling
NOTE:
Lights next to tie line buttons do
not
light
when you perform this procedure.
Press Conference to return to the administration menu
or leave administration mode by sliding the T/P switch
to the center position.
Administering a New
System
3-35