Filter
Top Products
6 Press
Message.
7 Press
Conference
to return to the administration menu
or leave administration mode by sliding the T/P switch
to
the center position.
IDENTIFYING JACKS
Refer to Form 1d, System Form-Station Planning for
FOR THE VOICE
Release 3,
or the Station Jacks section of the Master
ANNOUNCEMENT TO
Planning.Form for Feature Module 2. The form shows
BUSY VOICE
which analog voice terminals, if any, have been assigned
TERMINAL FEATURE
two
station jacks so that the Voice Announcement to Busy
Voice Terminal feature can be used.
Considerations
●
You must assign two consecutive analog telephone
jacks on the control unit to the voice terminal. The
first jack must have an odd jack number (even
intercom number) and the second jack the next higher
even jack number (odd intercom number). The
intercom number for the phone is the even intercom
number.
assign a phone either the Voice
●
You can
Announcement To Busy Telephone feature or the
Simultaneous Voice and Data feature but not both.
●
This feature is not available with basic telephones.
Follow the appropriate procedure below to identify any
station jacks in voice/voice pairs.
With a Display Console
1 Enter administration mode by sliding the T/P switch to
P.
2 Press Conference twice.
The administration menu appears.
3 Press
[Stations], [More], [More], [VceSgnl].
Administering a New System 3-43