Filter
Top Products
Testing Incoming and Test dial repeating tie lines when someone is available at
Two-way Dial the far end to place calls to your system. Follow these
Repeating Tie Lines steps:
1
2
3
4
At a preset time, the person at the far end places a dial
repeating call to your system by dialing the tie line
number of the voice terminal at which you are waiting.
You hear ringing at the designated voice terminal and the green
light flashes next to the button that has the tie line appearance.
Lift the handset.
The red light goes on next to the tie line button and the green light
becomes steady.
Verify two-way communication and then hang up.
Repeat this procedure for each tie line administered.
Completing the Installation
ATTACHING THE
CONTROL
COVERS
After wiring and testing the system, install the front and
top cover on the control unit. (Refer to Figure 2-27.) A
set of covers should be installed on both the basic carrier
and the expansion carrier. Make sure that there is a
module in the rightmost slot of each carrier so that the
covers are properly supported. If no functional module
occupies the rightmost slot of a carrier, install the empty
module that came with the system. Refer to Figures 2-28
and 2-29 as a guide when attching the covers to the
control unit.
2-106 Testing the System