Filter
Top Products
CHANGING SYSTEM
If you change the system size designation from small to
SIZE
large, or vice versa, the system reverts to the default
setting. See "Default Setings" on pg 3-15. In addition,
the line assignments will change on all attendant consoles.
NOTE:
Be sure to record the changes on the appropriate
planning forms.
With a Display Console
1
2
3
4
5
Enter administration mode by sliding the T/P switch to
P.
Press
Conference
twice.
The administration menu appears.
Press [System], [Size] .
Press
[Small] or [Large] for the system size wanted.
You see the message, "System is Re-starting..." The system
renumbers, then the administration menu appears on the display.
.
Continue administration or leave administration mode
by sliding the T/P switch to the center position.
With a BIS-34D Console
1
2
3
4
5
Enter administration mode by sliding the T/P switch to
P.
Press
Conference
twice.
Lights flash next to Adm Tel, Adm Pool Message and Speaker.
Press
Message.
Light goes on steady next to Message. Flashing lights go off.
Dial #201.
Two beeps sound.
Dial number to designate system size:
0
=
small
1 = large
Lights flash next to
Adm Tel, Adm Pool, Message
and
Speaker.
Administering a Changed System 3-65